Resistors used: Red - 82 ohm, Green - 56 ohm, Blue - 56 ohm. Allowing approximately 20 mA to flow through LED. Cathode (-) pins of RGB are connected to 8-bit PWM pins of Arduino for voltage control.

Here is an artistic Arduino project for the fun-minded. The circuit is an Arduino RGB LED controller running on a sweet ‘n’ simple code,but with a little hardware surprise outside the Arduino board.

This project demonstrates how to control an RGB LED using an Arduino. The project is specifically configured for Common Anode RGB LEDs. Bu proje, Arduino kullanarak bir RGB LED'in nasıl kontrol ...

A Tech Enthusiast has shared his new open-source project, the 9x9x9 LED Cube, which takes 3D visualization to the next level with its modular design and interactive features. This cube consists of 729 ...

[Fjord Carver] brings together an RGB LED and CdS Photoresistor to make a color sensor. Those Cadmium Sulfide lights sensors usually have a very wide swing of resistance when exposed to varying levels ...

Among quantitative analysis techniques, molecular absorption methods in the ultraviolet/visible region are the most commonly employed in chemical laboratories worldwide. In general, the absorbance ...

remove-circle Internet Archive's in-browser video "theater" requires JavaScript to be enabled. It appears your browser does not have it turned on. Please see your ...

Off the shelf RGB colour pickers allowing you to extract and objects RGB values can range from a few hundred dollars to thousands depending on your needs. If you would prefer to build your very own ...